Jura Impressa E4 - E8 (new models) brewing unit disassembly

crwdns2933809:0crwdne2933809:0

crwdns2935433:0crwdne2935433:0

Jura Impressa E4 - E8 (new models) opening procedure

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0

crwdns2936319:0crwdne2936319:0

crwdns2936315:0crwdne2936315:0

crwdns2936129:0crwdne2936129:0

crwdns2947189:0crwdne2947189:0

crwdns2915892:0crwdne2915892:0

crwdns2915888:0crwdne2915888:0

crwdns2936129:0crwdne2936129:0

crwdns2947189:0crwdne2947189:0

crwdns2915892:0crwdne2915892:0

crwdns2915888:0crwdne2915888:0

crwdns2931349:0crwdne2931349:0

crwdns2936071:01crwdne2936071:0 — Open the lid

There is a lid above the brewing unit. Begin by pulling off the silicone tube.

crwdns2936071:02crwdne2936071:0 — Remove the drainage tube

Remove the Torx T15 screw and remove the drainage tube.

crwdns2936071:03crwdne2936071:0 — Remove the brewing unit

The unit is attached with three deep Torx T15 screws. You will need a long-shaft screwdriver.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0