惠而浦干衣机电机测试和更换

crwdns2935425:04crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:04crwdne2931653:0

Test the run winding

You will need the wiring schematic for your dryer to figure out what terminal is for the run winding. On our example machine it is aligned with terminal 5.
Disconnect the run winding wire.
Be sure to grip the connector and not the wire when disconnecting.
Measure the resistance from the run winding terminal to the common terminal shared with the start winding.
This reading should be 2–5 Ω. If it is outside this range, the motor is defective and should be replaced.

测试运行绕组

您需要干燥机的接线示意图来确定运行绕组的端子。在我们的示例机器上，它与端子 5 对齐。
断开运行绕组线。
断开连接时，务必抓住接口而不是电线。
测量从运行绕组端子到与启动绕组共用的公共端子的电阻。
该读数应为 2–5 Ω。如果超出此范围，则电机有故障，应更换。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0