crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

惠而浦烘干机加热元件测试和更换

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:03crwdne2931653:0
Whirlpool Dryer Heating Element Testing and Replacement, Test the heating element: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Whirlpool Dryer Heating Element Testing and Replacement, Test the heating element: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Test the heating element

  • These steps will require a multimeter. If you aren't familiar with how to use one, here is a guide that will help you.

  • Many Whirlpool electric dryers have heating elements with two or even three sections. The resistance will vary according to the arrangement.

  • If the heating element has only two terminals, you will just check the resistance between those terminals.

  • The resistance should be about 10–13 Ω. If it is outside this range, the element should be replaced.

  • If there are three terminals (common on newer machines, and shown here), check the resistance between the middle common terminal and each of the element terminals.

  • The resistance should be about 20 ohms (Ω). If the resistance is less than 15 Ω, or greater than 25 Ω, you should replace the element.

测试加热元件

这些步骤需要使用万用表。如果您不熟悉如何使用万用表，本指南会对您有所帮助。

许多惠而浦电动烘干机的加热元件有两个甚至三个部分。电阻会根据排列方式的不同而变化。

如果加热元件只有两个端子，则只需检查这两个端子之间的电阻。

如果电阻值超出此范围，则应更换元件。

如果有三个端子（在较新的机器上很常见，如图所示），请检查中间的公共端子和每个元件端子之间的电阻。

电阻应约为 20 欧姆 (Ω)。如果电阻小于 15 Ω 或大于 25 Ω，则应更换元件。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0