crwdns2933423:0crwdne2933423:0

Google Pixel 7a リアカバーの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:014crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:04crwdne2931653:0
Google Pixel 7a Rear Cover Replacement, Insert an opening pick using the Anti-Clamp: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Insert an opening pick using the Anti-Clamp
  • While the heat from an iOpener is sufficient to separate the rear cover, it might cool down while you set up the Anti-Clamp. Reheat the rear cover if you need more time to set it up.

  • Place an object under your phone so it rests level while between the Anti-Clamp's arms.

  • Wait one minute, or until the adhesive separates, for a gap to form along the bottom edge of the phone.

  • Insert an opening pick into the gap between the rear cover and the frame.

  • If the adhesive doesn't separate, twist the handle clockwise one quarter turn and wait another minute. Apply more heat with a hair dryer or heat gun if the rear cover cools down.

  • Remove the suction cups from the phone using their pull-tabs and set the Anti-Clamp aside.

iOpenerの熱はリアカバーの接着剤を温めて、乖離するのに最適ですが、クランプを装着している間に熱が冷めてしまう可能性があります。装着作業に時間がかかる場合は、リアカバーを再加熱してください。

クランプのアームの間とデバイスが水平になるように、デバイス本体の下に何か物を置きます。

1分間もしくは接着剤が剥がれて、デバイス下端に沿って隙間ができるまで待ちます。

リアカバーとフレームの隙間にオープニングピックを差し込みます。

接着剤が分離しない場合は、ハンドルを時計回りに1/4回転ひねり、さらに1分待ちます。リアカバーが冷めてきたら、ドライヤーヒートガンでさらに熱を加えます。

デバイスから吸盤についてあるプルタブを押し出して装着を外して、クランプをデバイスから外して脇に置きます。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0