crwdns2933423:0crwdne2933423:0

Wie man einen Fön zum Aufweichen von Kleber benutzt

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:04crwdne2931653:0
How to Use a Hair Dryer to Soften Adhesive, Soften the adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 How to Use a Hair Dryer to Soften Adhesive, Soften the adhesive: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 How to Use a Hair Dryer to Soften Adhesive, Soften the adhesive: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Soften the adhesive
  • Position the nozzle of your hair dryer 2–3 inches above the device.

  • Move the hair dryer along the surface of your device.

  • Never leave your hair dryer in one spot for an extended period of time.

  • Heat the surface until it's hot to the touch, or as directed by the repair guide.

  • If you’re heating an OLED screen, don’t heat it over 176 °F (80 °C) or you may damage the OLED screen.

  • If you’re heating the adhesive underneath the battery, make sure the battery doesn’t go over 150 °F (66 °C) or you may damage the battery.

  • Make sure to turn off your hair dryer before setting it down to continue the repair.

Halte die Düse deines Föns in einem Abstand von 5-8 cm (2-3 Zoll) über dein Gerät.

Bewege den Fön in diesem Abstand über die Oberfläche deines Gerätes.

Lasse den Fön nie zu lange an einer Stelle.

Erhitze die Oberfläche bis sie sich heiß anfühlt bzw. folge den Anweisungen in der Reparaturanleitung.

Wenn du ein OLED-Display erhitzt, darf die Temperatur die 80 °C (176 °F) auf keinen Fall überschreiten, da sonst das OLED-Display beschädigt wird.

Wenn du den Kleber unter einem Akku erhitzt, achte darauf, dass die Temperatur die 66°C (150°F) nicht überschreitet, da sonst der Akku beschädigt werden kann.

Schalte deinen Fön immer aus, sobald du ihn ablegst.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0