crwdns2933423:0crwdne2933423:0

Desmontaje de la Pantalla

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:015crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:04crwdne2931653:0
Screen Removal: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Screen Removal: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Heat an iOpener and thread it through the arms of the Anti-Clamp so it lays on the right edge of the phone.

  • You can also use a hair dryer or heat gun—but extreme heat can damage the display and/or internal battery, so proceed with care.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick under the screen frame when the Anti-Clamp creates a large enough gap.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle clockwise half a turn.

  • Don't crank more than a half a turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next two steps.

Calienta un iOpener y pásalo por los brazos del Anti-Clamp de modo que quede apoyado en el borde derecho del teléfono.

También puedes utilizar un secador de pelo o una pistola de calor pero el calor extremo puede dañar la pantalla y/o la batería interna, así que procede con cuidado.

Espera un minuto para dar al adhesivo la oportunidad de soltarse y presentar un hueco de apertura.

Inserta una púa de apertura bajo el marco de la mampara cuando el cree un hueco lo suficientemente grande.

Si el Anti-Clamp crea una separación suficiente, aplica más calor en la zona y gira el mango media vuelta en el sentido de las agujas del reloj.

No des más de media vuelta cada vez y espera un minuto entre vuelta y vuelta. Deja que el Anti-Clamp y el tiempo hagan el trabajo por ti.

Sáltate los dos pasos siguientes.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0