crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Sostituzione dello schermo e della batteria del Wahoo Elemnt Roam (WFCC4)

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:017crwdne2931653:0
Wahoo Elemnt Roam (WFCC4) Screen and Battery Replacement, Connect Mainboard and Run Test: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Wahoo Elemnt Roam (WFCC4) Screen and Battery Replacement, Connect Mainboard and Run Test: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Connect Mainboard and Run Test

  • Connect the two ribbon cables for the USB connector and the battery to the mainboard

  • Press the Power button to test that the device starts correctly. Note: You'll have to directly press the small button on the left hand side of the mainboard to power up the device

  • Connect the device to a USB charger, to test that the device charges correctly

  • Note : GPS might not work at this stage. If you want to try it out, make sure the 4 pins on PCB are in contact with the the 4 bottom traces by pressing the two halves together firmly. Go under a clear sky.

Connetti la scheda madre e fai delle prove

Connetti i due cavi a nastro per il connettore USB e la batteria alla scheda madre

Schiaccia il pulsante di accensio e per verificare che il dispositivo si accenda correttamente. Nota: Dovrai schiacciare direttamente il piccolo pulsante sul lato sinistro della scheda madre per accendere il dispositivo

Connetti il dispositivo ad un caricatore USB, per verificare che il dispositivo si carichi correttamente

[title] Connect Mainboard and Run Test
[* black] Connect the two ribbon cables for the USB connector and the battery to the mainboard
[* black] Press the Power button to test that the device starts correctly. ***Note***: You'll have to directly press the small button on the left hand side of the mainboard to power up the device
[* black] Connect the device to a USB charger, to test that the device charges correctly
+[* black] ***Note*** : GPS might not work at this stage. If you want to try it out, make sure the 4 pins on PCB are in contact with the the 4 bottom traces by pressing the two halves together firmly. Go under a clear sky.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0