crwdns2933423:0crwdne2933423:0

Microsoft Surface Pro X 開口方法

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:019crwdnd2931529:0crwdne2931529:0

crwdns2935425:010crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:010crwdne2931653:0
Microsoft Surface Pro X Opening Procedure, Open the Surface: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Microsoft Surface Pro X Opening Procedure, Open the Surface: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Microsoft Surface Pro X Opening Procedure, Open the Surface: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Open the Surface
  • Do not remove the screen yet. It is still connected to the motherboard by the display cable. Keep the screen as close as possible to the Surface's frame to avoid straining the display cable.

  • Avoid hitting the battery with the screen during this procedure. A punctured or bent battery may leak dangerous chemicals or cause a thermal event.

  • Lift up the top edge of the screen so that it is at a 30° angle with the frame.

  • If you encounter any resistance, stop and check that all the adhesive is separated. Use an opening pick to cut through any remaining adhesive.

  • Rotate the screen so that its bottom edge is in the middle of the frame. The screen should be perpendicular to the frame.

  • Rotate the screen 90° so that it is facing down. Place the screen on the frame.

まだスクリーンを取り外さないでください。ディスプレイケーブルでマザーボードに接続されたままになっています。ディスプレイケーブルに負担がかからないように、スクリーンをSurfaceのフレームにできるだけ近づけてください。

この手順では、バッテリーをスクリーンに当てないようにしてください。バッテリーに穴が開いたり曲がったりすると、危険な化学物質が漏れたり、熱現象が発生したりすることがあります。

スクリーンの上端を30°の角度になるように持ち上げます。

抵抗がある場合は、一旦停止し、接着剤がすべて乖離していることを確認します。オープニングピックを使って、残っている接着剤を切り取ります。

スクリーンの下端がフレームの中央に来るように回転させる。スクリーンはフレームに対して垂直になるようにします。

スクリーンが下向きになるように90°回転させる。スクリーンをフレームにセットします。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0