crwdns2933423:0crwdne2933423:0

Saeco Minuto Test Mode

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0

      Turn off the machine at the power switch on the back.

      crwdns2936071:02crwdne2936071:0

      The first screen shows the technical data and the software version.

      crwdns2936071:03crwdne2936071:0

      In the next menu you can test the keys. Press one of the keys, then the display should turn red and the corresponding key should appear.

      crwdns2936071:04crwdne2936071:0

      The sensors are displayed in the third menu. H20 stands for water tank, DOOR for the door sensor, BU-P indicates the brew group sensor. N means no, of course, Y means yes.

      crwdns2936071:05crwdne2936071:0

      In the next menu you can test the brew group motor and the sensors for the end position. WORK is the upper end position, HOME is the rest position. CUR outputs the position of the drive shaft.

      crwdns2936071:06crwdne2936071:0

      The next screen is split. The electric valve can be seen on the left, closed here. Press the top left button to shift. On the right the pump or the impulses of the flowmeter. To test, press the top right button.

      crwdns2936071:07crwdne2936071:0

      The next screen is split again. On the left is the temperature of the heater, if you press the top left button, the heater will turn on and the temperature will increase. On the right you can check the grinder by pressing the top right button, key figures for the motor are displayed.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0