crwdns2933423:0crwdne2933423:0

Reemplazo del conjunto de pantalla del iPad Pro 12.9"

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:04crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:06crwdne2931653:0
iPad Pro 12.9" Display Assembly Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iPad Pro 12.9" Display Assembly Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • If your screen isn't getting hot enough, you can use a hair dryer to heat along the left edge of the iPad.

  • For complete instructions on how to use a hair dryer, check out this guide.

  • Insert an opening pick under the screen when the Anti-Clamp creates a large enough gap.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle clockwise half a turn.

  • Don't crank more than a half a turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next two steps.

Espera un minuto para darle al adhesivo la oportunidad de liberarse y presentar un espacio de apertura.

Si la pantalla no se calienta lo suficiente, puedes usar un secador de pelo para calentar el borde izquierdo del iPad.

Para obtener instrucciones completas sobre cómo usar un secador de pelo, consulta esta guía.

Inserta una púa de apertura debajo de la pantalla cuando el Anti-Clamp cree un espacio lo suficientemente grande.

Si el Anti-Clamp no crea un espacio suficiente, aplica más calor al área y gira la manija media vuelta en el sentido de las agujas del reloj.

No gires más de media vuelta a la vez y espera un minuto entre vueltas. Deja que el Anti-Clamp y el tiempo hagan el trabajo por ti.

Omite los siguientes dos pasos.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0