crwdns2933423:0crwdne2933423:0

iPad Pro 12.9" Displayeinheit

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:04crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:02crwdne2931653:0
iPad Pro 12.9" Display Assembly Replacement, Adhesive tip: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iPad Pro 12.9" Display Assembly Replacement, Adhesive tip: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Adhesive tip
  • Removing the screen involves using an opening pick or halberd spudger to separate the adhesive securing the screen to the frame.

  • As you slice through the adhesive, note the following:

  • The top has a large patch of thick adhesive. You'll need to slice 1/2" deep in order to cut the adhesive.

  • Don't slice deeper than 2 mm along the long edges of the iPad, or you risk damaging the display panel.

  • The lower edge also has thick patches of adhesive, but there are delicate flex cables in each corner. Don't slice deeper than 1/4" around the lower corners.

  • To help mark the iPad's orientation, you can apply a piece of tape to the top edge of the iPad screen.

Um das Display zu entfernen, musst du ein Plektrum oder einen Spudger mit Halbrundklinge (Halberd-Spudger) zum Auftrennen des Klebers zwischen Display und Rahmen benutzen.

Beachte beim Auftrennen des Klebers folgende Hinweise:

Am oberen Rand ist der Kleber ziemlich dick. Du musst etwa 13 mm tief einschneiden, um ihn aufzutrennen.

Schneide an den langen Seiten nicht tiefer als 2 mm ein. Es besteht sonst die Gefahr, dass das Displaypanel beschädigt wird.

Am unteren Rand ist der Kleber ebenfalls dick, aber hier gibt es empfindliche Flachbandkabel in jeder Ecke. Schneide nicht tiefer als etwa 6 mm in den unteren Ecken ein.

Als kleine Merkhilfe kannst du dir die obere Displaykante des iPads mit einem Klebeband markieren.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0