crwdns2933423:0crwdne2933423:0

Changement patins Logitech 502 Lightspeed

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935425:05crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:05crwdne2931653:0
Logitech 502 Lightspeed pre-Feet Replacement, Remove the rear foot: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Logitech 502 Lightspeed pre-Feet Replacement, Remove the rear foot: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Logitech 502 Lightspeed pre-Feet Replacement, Remove the rear foot: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the rear foot
  • Insert the tip of an opening pick underneath the rear foot starting at the gap in its recess.

  • When possible, grab with your fingers and slowly pull to peel it off completely.

  • When installing a new foot:

  • Use a spudger to carefully scrape up and remove any remaining adhesive bits.

  • Use isopropyl alcohol and a microfiber cloth to thoroughly clean all adhesive residue from the foot recesses. Allow the surface to completely dry.

  • Remove the feet from their backing and firmly press them into place.

Insérez la pointe d'un médiator sous le patin arrière, en commençant par l'interstice de son renfoncement.

Dès que possible, saisissez-le avec les doigts et tirez lentement pour le décoller complètement.

Lors de l'installation d'un nouveau patin :

Utilisez une spatule (spudger) pour racler et retirer avec précaution les morceaux d'adhésif restants.

Utilisez de l'alcool isopropylique et un chiffon en microfibres pour nettoyer soigneusement tous les résidus de colle dans les renfoncements du patin. Laissez la surface sécher complètement.

Retirez les patins de leur revêtement protecteur et appuyez fermement dessus pour les fixer en place.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0