更换罗技 G903 鼠标脚贴

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:01crwdne2931653:0

Heat the mouse foot

The feet are secured to the bottom of the mouse with strong adhesive. In order to cleanly remove them, the adhesive needs to be thoroughly heated.
Heat an iOpener and lay it on the mouse feet for one minute to heat the adhesive.
Alternatively, you can use a hair dryer on the Low heat setting to soften the adhesive.
If you're using a hair dryer, only heat the feet a few seconds at a time or you may warp the plastic shell.

	[title] Heat the mouse foot
-	[* icon_note] If you’re planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated to cleanly remove them.
-	[* black] [guide\|25705\|Heat an iOpener\|new_window=true] and apply it to the bottom mouse foot for two minutes.
-	[* icon_note] A hair dryer or heat gun may also be used, but be careful not to overheat the mouse—the internal battery is susceptible to heat damage.
+	[* icon_note] The feet are secured to the bottom of the mouse with strong adhesive. In order to cleanly remove them, the adhesive needs to be thoroughly heated.
+	[* black] [guide\|25705\|Heat an iOpener\|new_window=true] and lay it on the mouse feet for one minute to heat the adhesive.
+	[* icon_note] Alternatively, you can [guide\|157348\|use a hair dryer\|new_window=true] on the *Low* heat setting to soften the adhesive.
+	[* icon_caution] If you're using a hair dryer, *only heat the feet a few seconds at a time* or you may warp the plastic shell.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0