UK-830LN Disassembly

crwdns2936071:01crwdne2936071:0 — Please remove the case of the electrical tester

The case is made of flexible silicone and can be easily peeled off.

crwdns2936071:02crwdne2936071:0 — Loosen the 2 screws on the back.

Loosen (remove) the two screws on the back by installing the J1 (JIS1) standard screwdriver bit of the ifixit pro tech toolkit.

crwdns2936071:03crwdne2936071:0 — Open the rear panel by lifting only the lower part

At first, there is a latch on the upper part, so only the lower part is lifted as much as it is lifted without force.

crwdns2936071:04crwdne2936071:0 — intermediate internal cleanup

This step is inserted in the middle to show the internal structure

crwdns2936071:05crwdne2936071:0 — Remove the battery

Disconnect the 9V battery from the device.

crwdns2936071:06crwdne2936071:0 — To remove the motherboard, loosen the 4 screws.

Remove (unscrew) only the screws shown in the picture

crwdns2936071:07crwdne2936071:0 — internal structure

A = operation mode selection switch (inner connect)

crwdns2936071:08crwdne2936071:0 — internal structure

A' = Lubricated Steel Beads