crwdns2933423:0crwdne2933423:0

iMac Intel 27" Retina 5K Display 2020 Klebestreifen am Display ersetzen

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:022crwdne2931653:0
iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement, Test your repair: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement, Test your repair: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement, Test your repair: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Test your repair
  • At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips.

  • Gently insert the display data connector into its socket on the logic board. Be sure to press it straight into the socket, and insert it completely.

  • Flip the display data connector lock down onto the socket.

  • Insert the display power connector into its socket on the logic board.

Jetzt solltest du deine Reparatur überprüfen, damit du wirklich sicher sein kannst, dass der iMac gut funktioniert, bevor du ihn wieder verschließt. In den nächsten drei Schritten wird gezeigt, wie du die Displaykabel vorläufig anschließen und den iMac starten kannst, bevor du die Schutzfolien von den Klebestreifen abziehst.

Verbinde vorsichtig den Stecker des Displaydatenkabels mit seinem Anschluss auf dem Logic Board. Achte darauf, dass er gerade im Anschluss steckt und schiebe ihn ganz ein.

Klappe den Sicherungsbügel des Displaydatenkabelsteckers im Anschluss nach unten.

Stecke den Stecker des Displayversorgungskabels in seinen Anschluss auf dem Logic Board.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0