crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Desmontaje de JMGO GS1

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:011crwdne2931653:0
JMGO GS1 Disassembly, Main board: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 JMGO GS1 Disassembly, Main board: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 JMGO GS1 Disassembly, Main board: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Main board

  • Move the board a little bit to the side to expose the last connection.

  • The both connectors at the end of the cable are held in place by glue. Chose the one easier for you to disconnect.

  • When assembling back the device, there is no need to put glue back.

Placa base

Aparta la placa un poco a un lado para poder ver el último cable.

El cable está asegurado con pegamento en los dos conectores. Mira cuál de los dos tiene menos pegamento, y desconéctalo.

Cuando vuelvas a montar el proyector, no se necesita poner de nuevo pegamento en el conector.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0