crwdns2933423:0crwdne2933423:0

MacBook Pro 13" zwei Thunderbolt-Anschlüsse 2020 Touchbar entfernen

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:03crwdne2931653:0
MacBook Pro 13" Two Thunderbolt Ports 2020 Touchbar Removal, Prop Up Back Panel: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 MacBook Pro 13" Two Thunderbolt Ports 2020 Touchbar Removal, Prop Up Back Panel: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 MacBook Pro 13" Two Thunderbolt Ports 2020 Touchbar Removal, Prop Up Back Panel: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Prop Up Back Panel
  • While creating the gap between the Macbook and the back panel, insert an opening pick into the gap about 0.2in.

  • Don't insert the pick further, as this could cause internal damage

  • Move the pick towards the left side of the Macbook and around the corner edge.

  • Bring the pick up towards the top of the Macbook

  • Once you reach about the middle of the Macbook, you should hear a click. This is good! You have now unhooked part of the back panel.

Öffne einen Spalt zwischen MacBook und Rückabdeckung und setze ein Plektrum etwa 5 mm (0.2 in) in den Spalt ein.

Setze das Plektrum nicht tiefer ein, da dies Schäden am Gerät verursachen kann.

Schiebe das Plektrum in Richtung der linken Seite und um die Ecke des MacBooks herum.

Schiebe das Plektrum in Richtung Oberseite des MacBooks.

Sobald du ungefähr die Mitte des MacBooks erreicht hast, solltest du ein Klicken hören. Damit hast du einen Teil der Gehäuseunterseite gelöst!

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0