Nespresso CitiZ Brewing Unit replace

crwdns2936071:01crwdne2936071:0

Get the wires out of their holder.

crwdns2936071:02crwdne2936071:0

The plastic cover over the brewing unit is secured by two clips on each side. Use a metal spudger to pry them off.

crwdns2936071:03crwdne2936071:0

Open the lever and lift the cover out over the lever. Make sure that the cables are not strained too much.

crwdns2936071:04crwdne2936071:0

Use a Torx T10 screwdriver to remove the four screws securing the brewing unit.

crwdns2936071:05crwdne2936071:0

Use a metal spudger and insert it into the seam between the inner coffee spout and the brewing unit. Pry off the coffee spout.

crwdns2936071:06crwdne2936071:0

The brewing unit now remains only attached to the hot water hose. Use the metal spudger to pull out the metal clip at the end of the hose.

crwdns2936071:07crwdne2936071:0

Lift the brewing unit from the device.