crwdns2933423:0crwdne2933423:0

Replace Saeco Moltio heater

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0 — Decorative frame made of metal or plastic?

      First check which model you have in front of you: is the decorative frame made of chromed metal (image 1) or made of metalized plastic (image 2). In the first case use this guide, in the second case use this guide. Then come back here.

      crwdns2936071:02crwdne2936071:0 — Replace water heater

      If the support plate for the exchangeable bean container has already been removed, you can skip this step.

      crwdns2936071:03crwdne2936071:0

      The instantaneous water heater is now clearly visible. It is still hidden under a gray plastic cover. The cover is attached with two latches. The one on the back is a bit difficult to access.

      crwdns2936071:04crwdne2936071:0

      The holder of the instantaneous water heater is fastened with three Torx T10 screws. (The third is here covered by the heater). remove those.

      crwdns2936071:05crwdne2936071:0

      The Oetiker clamps on the hose connections must be cut open with side cutters.

      crwdns2936071:06crwdne2936071:0

      Remove the Phillips #2 screw on the thermal switch holder.

      crwdns2936071:07crwdne2936071:0

      When reassembling, the Oetiker clamps can be replaced with a 9mm hose clamp.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0