crwdns2933423:0crwdne2933423:0

DeLonghi ETAM series upper brewing piston replacement

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0

      There are six connections on the upper brewing piston: three hot water pressure lines, one non-pressurized waste water line, a hose line to the coffee spout and two cables to the microswitch. All must be removed first.

      crwdns2936071:02crwdne2936071:0

      Disconnect the two spade connectors from the microswitch

      crwdns2936071:03crwdne2936071:0

      Take off the black bend protector on the middle pressure line.

      crwdns2936071:04crwdne2936071:0

      Unscrew the two Allen screws (4 mm).

      crwdns2936071:05crwdne2936071:0

      Unscrew the Phillips screw on the black protective plate on the left and pull off the protective plate.

      crwdns2936071:06crwdne2936071:0

      Using a flat tool, disconnect the drain hose on the left.

      crwdns2936071:07crwdne2936071:0

      Remove the two Phillips screws securing the side of the upper piston support plate.

      crwdns2936071:08crwdne2936071:0

      Pull off the hose to the coffee spout.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0