DeLonghi ETAM Opening side panels

crwdns2936071:01crwdne2936071:0

Disconnect the power plug and remove the power cord from the device.

crwdns2936071:02crwdne2936071:0

The bean compartment flap must be removed. It is latched on the left and right, the latch is held under tension by a spring. Compress the spring until the catch is free and lift off the flap.

crwdns2936071:03crwdne2936071:0

There is a plastic cover strip under the flap. It is only latched in place. Release it with a flat tool and lift it out.

crwdns2936071:04crwdne2936071:0

Lift the back side up and put it aside.

crwdns2936071:05crwdne2936071:0

The side covers are still attached to the back with two screws. They are located under a cover strip that is only snapped in place. Take off the cover strip and put it aside.

crwdns2936071:06crwdne2936071:0

Push the left side panel back about 1 cm. It often jams strongly and you have to help it with a plastic opening tool.

crwdns2936071:07crwdne2936071:0

The right side panel is removed in the same way, but the service hatch is a bit obstructive. Open it first and push the side panel back a few millimeters. This is often difficult and you will need a plastic lever tool.