crwdns2935433:0crwdne2935433:0
How to open a Jura Impressa S model cover
Jura Impressa S model backpanel
Jura Impressa S Model right-side panel removal
crwdns2935355:0devicecrwdnd2935355:0crwdnd2935355:0crwdne2935355:0
crwdns2935335:0crwdne2935335:0
crwdns2935381:0crwdne2935381:0
crwdns2936071:01crwdne2936071:0
Unscrew the Torx T15 screw that holds the control board in place.
crwdns2936071:02crwdne2936071:0
The pump support is like a drawer that can be pulled out to the rear. Two latches hold it in place on the left and right.
crwdns2936071:03crwdne2936071:0
Pay attention to the diaphragm regulator when pulling it out. You have to push it up a bit so that the whole pump housing can slide out.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0