crwdns2933423:0crwdne2933423:0

Dewalt Nailer DCN21PL 2018 Opening Procedure

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:014crwdne2931653:0
Dewalt Nailer DCN21PL 2018 Opening Procedure, Remove board and switches: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Dewalt Nailer DCN21PL 2018 Opening Procedure, Remove board and switches: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Dewalt Nailer DCN21PL 2018 Opening Procedure, Remove board and switches: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove board and switches
  • The two switches and four detent springs are only held in place by the plastic casing, so they may fall out when you remove the board—this is fine.

  • Grasp either side of the main circuit board and slowly pull it up and out of the slot in the casing.

  • Reassembly tip: note the correct location and orientation of the two switches and their detent springs.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0