crwdns2933423:0crwdne2933423:0

Raptor 2 / T REX 3 Y End Stop Adaptor

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:01crwdne2931653:0
Raptor 2 / T REX 3 Y End Stop Adaptor, Y End Stop Adaptor: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Raptor 2 / T REX 3 Y End Stop Adaptor, Y End Stop Adaptor: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Raptor 2 / T REX 3 Y End Stop Adaptor, Y End Stop Adaptor: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Y End Stop Adaptor
  • Retain all fasteners until after assembly.

  • Find the file for printing at http://bit.ly/2RFHGyT

  • To start this process, you will need to remove all 4 corner leveling knobs. There may also be a star washer between the knob and Y carriage plate on each corner.

  • The screw that is not allowing the new chain to sit flat, needs to be removed. Use an M2.5 hex for this.

  • The screw is no longer needed.

  • The raised part sits closer to one side. It should face the end stop.

  • Test fit the printed part first to make sure it sits all the way flush.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0