crwdns2935425:01crwdne2935425:0
crwdns2931653:01crwdne2931653:0
Y End Stop Adaptor
-
Find the file for printing at http://bit.ly/2RFHGyT
-
To start this process, you will need to remove all 4 corner leveling knobs. There may also be a star washer between the knob and Y carriage plate on each corner.
-
The screw that is not allowing the new chain to sit flat, needs to be removed. Use an M2.5 hex for this.
-
The screw is no longer needed.
-
The raised part sits closer to one side. It should face the end stop.
-
Test fit the printed part first to make sure it sits all the way flush.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0