CR-10S BL Touch Install

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:02crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936325:0crwdne2936325:0

crwdns2931653:02crwdne2931653:0

CR-10S BL Touch Install, Install 1a.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

CR-10S BL Touch Install, Install 1a.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

CR-10S BL Touch Install, Install 1a.: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Install 1a.

With the grommet loose, you can feed harness A through the grommet with the 2 and 3 pin connector going first.
Feed it through the hole in the rear of the control box.
Leave 4-5 inches of the loose pins and reinstall the grommet.
Make sure the grommet is fully seated into the hold.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0