CR-10S Pro BL Touch Install

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:03crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936325:0crwdne2936325:0

crwdns2931653:03crwdne2931653:0

CR-10S Pro BL Touch Install, Top Section 1c.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

CR-10S Pro BL Touch Install, Top Section 1c.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

CR-10S Pro BL Touch Install, Top Section 1c.: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Top Section 1c.

Cut 2 zip ties.
Remove 3 button head screws using M2 hex to remove the daughterboard cover.
Unplug the original probe connector. It may have glue on it so pull on the connector, not the wires.
Daughterboard is marked with pink arrows.
No jumper needed for this install. We will not be using Z- port so these instructions are specific to using our firmware!

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0