How to Build a Waterproof Pressure Sensor

crwdns2935425:06crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:06crwdne2931653:0

Attach Wires

A wire is necessary on the ground, SDA, SDO, SCK, CS, Vd and VdIO pins. These can be identified from the top of the board.
Insert the stripped section of the wire into the through hole, and solder into place.
Repeat for all seven wires. Electrical tape can cover any exposed shielding if needed.
Tip: consider which way you want your wires to run. You can solder them on either side of the board.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0