Resecure cables to the machine

Make sure you secure the cable bundle on each end of the cable chain with a cable tie.

Be sure to trim cable tie ends off flush so they are not sharp.

Tighten up the frame side chain hold down with a M2.5 hex wrench. This side uses a T Nut and you need to make sure the chain is tight to the frame before proceeding.

This screw triggers the end stop. Make sure you position the chain so that it is clear of this screw.

Reinstall bed heater connections to the relay. They are not polarity specific (side does not matter).

Using a #1 phillips screwdriver, tighten the screw terminals.