MFC-J4410DW Flushing Box Replacement

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:017crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:017crwdne2931653:0

MFC-J4410DW Flushing Box Replacement, Removing the tube support plate: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

MFC-J4410DW Flushing Box Replacement, Removing the tube support plate: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

MFC-J4410DW Flushing Box Replacement, Removing the tube support plate: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Removing the tube support plate

Tilt open the control panel to release the tilt hook stopper.
There's a button on the underside of the control panel to allow it to fold back in.
Release the retaining tab with your finger or a metal spudger.
Remove the tube support plate.
There's no need to remove the ink tubes and flat harnesses. Just set the tube support plate out of the way on the printer. Take care not to crimp the ink tubes.
When reinstalling, make sure the black switchback sensor harness does not get left under the tube support plate.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0