crwdns2933423:0crwdne2933423:0

Saeco Minuto brewing unit gasket replacement

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0

      Open the hatch on the side panel and remove the brewing unit.

      crwdns2936071:02crwdne2936071:0

      The spout for the hot coffee is located on the top of the brewing unit. It is fastened with two screws. Underneath is the crema valve. It consists of a spring and a little glass ball. Make sure the spring is reinserted with the thin end touching the glass ball when re-assembling.

      crwdns2936071:03crwdne2936071:0

      The upper piston is held in place in the frame with four locking pawls. Push down all four latches with a spudger, then remove the piston by pushing it downward.

      crwdns2936071:04crwdne2936071:0

      There are three Torx T10 screws in deep blind holes that hold together the two parts of the brewing unit. Unscrew them and lift off the upper side panel.

      crwdns2936071:05crwdne2936071:0

      Now you can disassemble the brewing unit into its three main parts: the brewing unit and the two side panels.

      crwdns2936071:06crwdne2936071:0

      You can push out the lower piston from the brewing unit if you snap the deflection lever out of its socket with a screw driver.

      crwdns2936071:07crwdne2936071:0

      Take this opportunity to carefully replace the two O-rings on the support valve. The larger one is at the top. These two seals are stressed during every brewing process. Therefore, lubricate them with food-safe silicone grease.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0