crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Reemplazo del elemento calefactor de Revlon 473

crwdns2935421:0crwdne2935421:0

crwdns2935425:02crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:02crwdne2931653:0
Revlon 473 Heating Element Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

  • To test the heating element, use a digital multimeter.

  • Set the multimeter to 200 under ACV (alternating current voltage).

  • Bring the ends of the multimeter toward the two lead wires.

  • If the circuit between the wires is closed, the numbers on the multimeter should keep changing.

  • If the numbers are not changing, replace the heating element.

  • If the circuit is closed, check the thermal cutout.

Para probar el elemento calefactor, utiliza un multímetro digital.

Ajusta el multímetro a 200 en CA.

Acerca los extremos del multímetro a los dos cables conductores.

Si el circuito entre los cables está cerrado, los números del multímetro deberían seguir cambiando.

Si los números no cambian, reemplaza el elemento calefactor.

Si el circuito está cerrado, verifica el interruptor térmico.

[* black] To test the heating element, use a digital multimeter.
-[* black] Set the multimeter to 200 under ACV.
+[* black] Set the multimeter to 200 under ACV (alternating current voltage).
[* black] Bring the ends of the multimeter toward the two lead wires.
[* black] If the circuit between the wires is closed, the numbers on the multimeter should keep changing.
[* black] If the numbers are not changing, replace the heating element.
[* black] If the circuit is closed, check the thermal cutout.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0