crwdns2935425:010crwdne2935425:0
crwdns2931653:010crwdne2931653:0
-
Push the locks up to release the lens servo motor cables. Gently remove the cables out of their sockets.
-
Unscrew the #00 Phillips holding a grounding wire against sensor shield.
-
At this point, you can choose to cut or de-solder the white wire from the board. It is the remote flash sync wire.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0