crwdns2915892:0crwdne2915892:0
If your Eufy Robovac G32 Pro's power and control buttons aren't working, then follow this guide to replace them. There are three main power and control buttons, a spot cleaning button, a recharge button, and an auto cleaning start/pause button. The power and control buttons could not be working due to something blocking the sensor, or the board itself is broken.
crwdns2942213:0crwdne2942213:0
-
-
Make sure your device is turned off.
-
Flip the device upside down on a flat surface.
-
-
-
Press the clips at the bottom of the device that are indicated by the downward facing arrows.
-
Take off the rolling brush cover.
-
-
-
Pull the rolling brush up on the right side. Remove the rolling brush.
-
-
-
Orient the device so the underside is facing up.
-
Remove the eight 9.3 mm screws securing the bumper brackets using a Phillips #1 screwdriver.
-
Remove the bumper brackets.
-
-
-
Lift the bumper off of the device gently.
-
Use your fingers to disconnect the 8 pin connector.
-
-
-
-
Remove the two 10 mm screws using a Philips #1 screwdriver.
-
-
-
Lift the bump sensor off using your fingers.
-
-
-
Remove the dust collector by grabbing under the lip and pulling it out.
-
-
-
Remove the two 5.5 mm screws using a Philips #1 screwdriver.
-
-
-
Remove the eight 14 mm screws using a Philips #1 screwdriver.
-
-
-
Lift the bottom housing towards the front.
-
-
-
Remove the six 5.5 mm screws securing the button board with a Phillips #1 screwdriver.
-
-
-
Grab the 8 pin connector with your hands and firmly pull it away from the board.
-
Remove the board.
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
crwdns2915084:0crwdne2915084:0
University of North Texas, Team 2-5, Coppersmith Fall 2024 crwdns2935289:0University of North Texas, Team 2-5, Coppersmith Fall 2024crwdne2935289:0
UNT-COPPERSMITH-F24S2G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:04crwdne2935297:0
