crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

Hot Tools HPK12 Prerequisite Only

crwdns2936025:06crwdne2936025:0 —
crwdns2916944:0crwdne2916944:0

crwdns2931533:0crwdnd2931533:0crwdnd2931533:0crwdnd2931533:04crwdnd2931533:0crwdne2931533:0

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Use your JIS #0 screw driver to remove the two 6mm “J0” screws that are attached to the flat iron base and set them aside.

Lift the backing plate upwards to remove it from the flat iron.

Use the Phillips #0 screwdriver to remove two 4mm “PH0” screws that attach the circuit assembly to the flat iron base.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0