To attach the handbrake cable to the handbrake you will need to lift the rear 'dogbone' out of the way (as shown) and remove the handbrake assembly from the shifter chassis.

Attach the cable using the supplied clevis and E-Clip, then refit the handbrake assembly into the shifter chassis. Be sure that the wider spacers are to the right hand side of the assembly - this is to give clearance for the shifter cables.

Note: Some cables can be quite tight, so be sure you have carried out Step 6 to loosen the cable.

Adjust the handbrake cable beneath the car to remove any slack. When happy, refit the rear floorpan.

Reassemble the handbrake being sure that the wider spacers are to the right hand side of the assembly - this is to give clearance for the shifter cables.

Fit the handbrake switch to the Shifter Chassis using the supplies M3 bolts.

Note: The switches vary, so may require a degree of adjustment to work.