There is another circuit board affixed to the LCD chassis (back covering) that must be removed before the chassis can be unscrewed.

The glue holding this component on is strong; it takes patience to pry off the plastic covering without separating it from the electronics inside. Pry with a spudger in small increments. With patience, it will come undone.

Finally, begin removing the chassis of the LCD screen by removing the 6 screws (4.5mm) found around the perimeter of the chassis with a PH00 screwdriver. The sevelth screw, circled in yellow, is stationary and must simply be loosened.

As with the other screw sets, it is recommended you set these screws aside in their own area to avoid confusion.