Cut a 30 cm long cord (for a table).

Cut cable 1.3 m long cable (shelves).

The wire is insulated at both ends. Setting the insulation pliers at the 10 mm mark.

A quick-connect contact is clamped to one end of the cord.

The loop contact is pressed onto the other end and a pin with a hammer is hammered onto it.

Only the red pliers mark is used to clamp the contact.

Check with your fingers that the head clip does not rotate around its axis. If it rotates, the clamp must be replaced with a new one.

For both wires, one end is terminated with a quick-connect contact, the other end with a pin with a head.