Once the border is removed, another circuit board is revealed. There is a great amount of consistency with the other boards as it is being held in place by screws.

At the top of the device a coper wire runs through the perimeter of the device and is snapped into place connecting the two halves.Gently remove this wire.

At the bottom of the device, a blue cord runs through the perimeter and can carefully be plucked out.

A couple of screws holding the circuit board into place are hiding in the top left corner of the device. (Pic 6) Removing them will loosen the metal bolt that helps the device close (Pic 7) and can be separated from the base.

After the screws are taken out, you can lift up the circuit board.

To reassemble your device follow these instructions backwards.