To work on this replacement, you will need to gain access to the bottom. It is best to place the washer on its front. Place a few old blankets etc. so as not to scratch the front to much. Since I did a total rebuild on this washer, I had also removed the control panel. It was easier for me to place the washer upside down :-)

Not shown here is that you need to unplug the washer as well as disconnect the water supply hoses prior to working on it!

First the pulley cover has to be removed. It is attached via two 5/16 bolts

Use an electric screwdriver with a short extension and a 5/16 socket to remove the right screw,