crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

Canon A-1 Light Seal Replacement

crwdns2936025:09crwdne2936025:0 —
crwdns2916944:0crwdne2916944:0

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Measure the length of the areas where the new light seals will be placed.

Use scissors to cut the measured length of your new high-density foam.

Trim the new foam to a width of about 2-3 mm.

It’s okay if the foam is slightly wider than 2–3 mm, as it will compress into the grooves of the camera.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0