Prying off the case shell (302g), it has the 'Zeiss Ikon' and 'Movielux' embossed in brass, attached using metal wires that hook into tiny slotted holes in the case.

The mild steel case clicked onto the main frame snugly, with little grooves that slotted into the film arm holder. Suction keeps the shell on tight as it is a snug fit, there is no rubber gasket or lining.

Finger hole on the bottom for ease of access when opening.

Case is stamped and made out of mild steel, hand painted on the inside, power-coated on the exterior.

Length: 233mm

Width: 45mm

Height: 154mm

All dimensions throughout teardown are labelled as the projector in standing position (i.e. this case is laid flat, but its original position is upright)