Once you've got the faceplate off, on the backside of the faceplate you will see a white PCB with 4 J00 screws securing it, remove those 4 screws

There are two alignment posts holding the board in place, while removing the board be careful not to damage these posts

These screws go into plastic, so when reassembling at this step, be very careful not to overtighten them

While the flat flex cable can be disconnected, the white wire is soldered to the other side of the board, so be very careful to not damage it.

For this guide we are not disconnecting either cable, simply be aware they're there and be cautious of them