Remove bottom panel of laptop removing all the screws which should be differing sizes. Which should be ten 4 long on the top near the rear exhaust vents

Now using a guitar pick or thin wedge plastic tool go along the edge of the bottom panel between black bottom panel and were it meets the underglow light bar starting on the corner going toward the edge were it meets the side vents then take out wedge and begin working that edge were the sidevent starts keyboard deck begin. ease clips out of place.

Pay extra attention when getting near the side vents use a very slim pry tool. once both side vents are unclipped and entire side near under light bar is unclipped should come apart from chassis easily if not you still have clips to unclip using wedge, guitar pick, or slim pick tool