crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

1. BLV Ender 3 V2 Disassembly

crwdns2936025:08crwdne2936025:0 —
Final Results

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

It's a good idea to remove the PSU entirely. Remove the 4x phillips screws.

This is how your frame should look at this point.

If you're going to be using my SKR3 EZ mount you will need to tap these 2 holes on the right front side of the 4040 extrusion with a M5 tap.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0