crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

Replacing Duet 2 WiFi with Fysetc Spider v2.2

crwdns2936025:010crwdne2936025:0 —
Building Fysetc Spider Firmware 3

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Run the following:

make

make flash FLASH_DEVICE=####:####

Using the ID you notated earlier in place of ####:####

Power off the Spider. Remove the jumper and press the reset button on the board.

Run the following

ls /dev/serial/by-id/* or lsusb

This is the ID you will put in printer.cfg

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0