crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

Adding ADXL345 Accelerometer

crwdns2936025:04crwdne2936025:0 —
Preparing printer.cfg

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Uncomment the input shaper & resonance tester section in the config.

probe_points: It's recommended to use 1 point in the center of the bed slightly above. I used the same coordinates used when homing Z

Restart klipper with

RESTART

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0