crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

How to Repair the Creality3D Ender 7 Z-axis Control

crwdns2936025:02crwdne2936025:0 —
Mechanical mounting of the driver

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Disconnect the power cable again and open the bottom of the printer

There is enough space to place the driver as on the picture.

You need to drill two hole in the frame on the back for the two screws to hold the driver.

Take you time to mark where you need to drill as it will be visible from the outside later.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0