The front cover of the device is made of recycled plastic and is press-fit onto the body. It's connected to the body by a flex cable, which can be disconnected easily by hand.

To remove the front cover, insert a simple pick into the seam between the front and back housing and gently pry along the seam.

If the cover is difficult to remove, you may need to use a flathead screwdriver to rotate and lift it off the body.

As the front enclosure starts to loosen, it will begin to "pop" off. Carefully flip up the front enclosure to access the flex cable, and disconnect the cable to remove the front enclosure.

On the underside of the outer front enclosure, you'll find the touch sensors and a small daughter board secured by three Torx Plus (IP) screws.