crwdns2933423:0crwdne2933423:0
crwdns2918538:0crwdne2918538:0

Dewalt Nailer DCN21PL 2018 Opening Procedure

crwdns2936025:014crwdne2936025:0 —

crwdns2931533:0crwdnd2931533:0crwdnd2931533:0crwdnd2931533:02crwdnd2931533:0crwdne2931533:0

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

The two switches and four detent springs are only held in place by the plastic casing, so they may fall out when you remove the board—this is fine.

Grasp either side of the main circuit board and slowly pull it up and out of the slot in the casing.

Reassembly tip: note the correct location and orientation of the two switches and their detent springs.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0